Principles of Implant Corset Design (Part I)

 

 

Principles of Implant Corset Design (Part I)
 
The implant body crests are an ultra-oscillatory region that extends over the upper part of the implant body and coordinates anti-rotating components at the implant's abutment joint. The implant corset pattern is one of the most important components of the implant, which is in the overall design quality. Implants are important. In the design of an implant, a biotic width, force considerations (as a region in which the focus of mechanical stress is high) plays a special role and plays a role in the prosthesis. In fact, this area of ​​the implant body, in the overall design The body of the implant is decisive.
 

 

 

 

The role of corset during the surgical phase affects the surface of the implant corset, since the implant corset area should be slightly larger than the thead (external) diameter of the implant body of the tooth, thus the cyst plays its role fully, and the barrier vs. Bacteria or fibrous tissue during the initial repair phase.
  
This seal, created by the Corset Implant area, causes the primary stability of the majority of the implant after placement in the bone. This problem is more important in the weaker bones because the area of ​​the crystal bones bones.
The greater the diameter of the implant corset also increases the contact surface, and this reduces stress in the crystal region, in fact, every 2. Mm increase in the diameter of the corset, 5 /. Increases contact level.
 
The other advantage of increasing the diameter of the implant corset increases the binding surface with the abutment, and as a result, the stress is reduced to the abutment screw while the lateral forces decrease, and the risk of loosening the abutment screw decreases by breaking the screw.
In fact, the dimensions of an implantable abutment binding plate in reducing stress on the implant screw are more important than height with an abutment counter-rotating hex depth. The smoothness of the implant corset is to reduce the accumulation of microbial plaque and improve that area by the individual. However, Corset region Implants in two-piece implants are initially placed in the lower bone.
Consequently, if that area does not cause problems every day, if it is not clean, until it occurs in the bone crust.
In this case, depending on the depth of the gingivitis, which is 3 mm above the bone, and the toothbrush hair is up to a maximum of 5. Up to 1 mm can be inserted into the gingival gland, so after bone analysis around the implant chest, cleaning the depth of the silt in normal way can not be done, because the depth of the slashes also increases after bone resorption.